Table of Contents
Advertisement
DATANET-30 General Assembly Program may be modified for 4k memory GE-225's to accept
up to 500 symbols.
These binary corrections are listed below and should be inserted before assembly program O:
Assembly Program O
LOCATIONS
000538
000548
CONTENTS
7648
77768
This binary correction card should be inserted before the assembly program 1 transfer card.
LOCATIONS
CONTENTS
Assembly Program 1
Tape General Assembly Program Operating Instructions
To run the Tape General Assembly Program:
1.
Mount the DATANET-30 General Assembly Program systems tape on handler 1. Mount
working tapes on handlers 3, 4 and 5, with the write-permit rings in place.
If
console
switch 6 is set, mount a working tape on handler 6.
2.
Load the input deck into the card reader.
It
should be set up as follows:
(If symbolic program is on magnetic tape,
mount the tape on handler 3 and set console switch 16.)
3.
Depress RESET ALARM and RESET A, LOAD CARD, and RESET P. Depress AUTO
and START.
The assembly program will be called in and will run from start to completion. Error messages
are the same as described in preceding pages.
GENERAL ASSEMBLY PROGRAM 3 - PAPER TAPE CONVERSION
Assembly program 3 (see flow chart in Figure A-3) is a magnetic tape or cards-to-paper-tape
conversion program.
It
may be run from the systems tape or by loading the assembly program
3 program from punched cards. The minimum hardware requirements are as follows.
1.
Card reader or magnetic tape
2. Paper tape punch
4.
Typewriter.
@&v&~~uc:J ~®------------
A-11
Advertisement
Table of Contents
