Miscellaneous - Medisana 51296 Manual

5.2 Deleting memory

Press M-button
If you only want to delete the last measured value, press and hold the SET / SNOOZE -

button for approx. 7 seconds. The last measured value will flash two times and will
then be deleted. The display shows "dEL". Press START/STOP
lete mode. If you want to delete all stored values in memory for a user, press and hold

M-button AND SET / SNOOZE - button
The display shows "dEL ALL". Now press the
the deletion. The display shows "dEL OK" - now all stored values for this user are de-
leted and the unit will switch off automatically. If you want to abort the deletion process,
press START/STOP
itself off without deleting any value.

6 Miscellaneous

6.1 Error messages and error remedying
Error indicators:
Symbol Cause
+ Lo Low battery
Bluetooth transfer of
+ Err
data not possible
E1 Cuff not properly
fitted
Cuff too tight
E2
E3 Failure during
inflation
E10/E11 Movement or speaking
during measurement or
pulse too weak
E20 Pulse cannot be
detected
E21 Measurement failed
Calibration error
EExx
to enter the memory recall mode.

while the display shows "dEL ALL". The unit then switches
5 Memory / 6 Miscellaneous

simultaneously for approx. 10 seconds.
SET / SNOOZE - button
Correction
The built-in battery is too low or empty.
Charge the battery.
Check the software and if Bluetooth is properly
configured and activated on the receiving units.
Wrap the cuff properly. Remeasure in correct
way.
Wrap the cuff properly. Remeasure in correct
way.
Wrap the cuff properly. Check, if the air hose
is properly connected to the unit. Remeasure
in correct way.
Rest 30 minutes and
way. Do not speak or move during the
measurement.
Wrap the cuff properly. Remeasure in correct
way.
Rest 30 minutes and remeasure in correct
way.
Wrap the cuff properly. Remeasure in correct
way.

, to exit the de-

to confirm
remeasure in correct
GB
i
27