Table of Contents
Advertisement
Available languages
Available languages
WARNING - BATTERY SAFETY INFORMATION
• Do not disassemble batteries!
• Increased risk of leakage, avoid contact with skin, eyes and mucous
membranes! If battery acid comes in contact with any of these parts,
rinse the affected area with copious amounts of fresh water and seek
medical attention immediately!
• If a battery has been swallowed seek medical attention immediately!
• Keep batteries out of children's reach!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Do not throw used batteries into the household refuse; put them in a
hazardous waste container or take them to a battery collection point, at
the shop where they were purchased!
• The battery of this device must only be exchanged by specialized
personnel. Never try to disassemble the battery on your own, but
contact the service centre!
3.3 Setting the date, time and alarms
1.
Before using the unit, you need to put the LOCK-switch
In "OFF" (red) - position the Bluetooth function is deactivated and all buttons are
locked.
2.
Press and hold the SET / SNOOZE - button
3.
First of all the month figure starts to flash. Press M-button
month figure.
4.
Press the SET / SNOOZE - button
5.
Now the day figure starts flashing. Proceed accordingly for the input of day, year,
hour and minute (as described under point 3 and 4).
6.
Now the setting for the two alarms follows. During adjustment of the first alarm time,
"
" appears in the display
cond alarm time. Adjust the hours and minutes of both alarm times in the same way
as described under point 3 and 4 with the help of the M-button
the SET / SNOOZE - button
7.
On completion of the date and time setting, "Ok" appears on the display. The unit
switches off automatically after about 60 seconds, if no buttons are pressed in order
to save power.
3.4 Selecting the mode of operation
The MEDISANA Upper arm blood pressure monitor with travel alarm clock BU
575 connect features two different operation modes:
a) The clock / alarm mode
The clock/alarm mode is activated by placing the device in an upright position, e.g. on
a table. In clock/alarm mode the LC-display shows the date as well as hour and minute:
to confirm the setting.
. "
" appears during adjustment of the se-
to confirm the setting.
e. g. 3:30 p.m. on 18 of July
3 Getting started
to position "ON" (green).
for at least 3 seconds.
to adjust the actual
th
GB
i
i
i
i
i
to adjust and
i
23
Advertisement
Table of Contents
