Cub Cadet 2000 Series Professional Shop Manual page 59

O-rings
Figure 5.34
Brake assembly
Figure 5.35
Flange
Figure 5.36
5. Inspect the o-rings at the end of the hydraulic pick up
tube. See Figure 5.34.
NOTE: Two O-rings normally seal the lower end of the
pick up tube.
6. Remove the two screws that secure the brake
assembly to the right transmission housing using a 3/
8" wrench. See Figure 5.35.
7. Remove the brake disk from the output shaft.
See Figure 5.36.
NOTE: The center flange of the brake disk faces outward.
8. Remove the inside brake pad from the right transmis-
sion housing.
NOTE: The factory glues the inside brake pad to housing
during assembly.
Drive
53