Cub Cadet 2000 Series Professional Shop Manual page 43

Figure 4.32
Figure 4.33
NOTE: The seat switch connector on the GTX2154LE must be wire tied back together and attached to the
seat frame. Failure to do this can cause the connector to get caught in the seat bracket and rip the
wires out of the seat. If this happens, the tractor will shut down when the brake is released and the
whole seat must be replaced.
11. Remove the two screws, indicated by the arrows in
Figure 4.32, from the bottom of the operators side of
the dash using a 3/8" wrench.
12. Remove the two screws, indicated by the arrows in
Figure 4.33, that holds the base of the left side panel
to the frame using a 1/2" wrench
13. Lift up on the dash enough to disconnect the RMC
module and the key switch.
14. Lift the dash panel off of the tractor.
15. Assembly notes:
• Assemble tractor by reversing the disassembly
process.
• Tighten fasteners to a torque of 20-22 in-lbs. (2.25-
2.50 N-m).
• Test all tractor controls and features before return-
ing the tractor to service.
Body
37