Cub Cadet 2000 Series Professional Shop Manual page 38

2000 Series Tractors
NOTE: On the GTX2154LE:
• Remove the four screws, indicated by the
arrows in Figure 4.17, that hold the seat frame
to the fender using a 7/16" wrench.
• Remove the two screws that hold the rear of the
fender to the frame using a 7/16" wrench.
On manual deck lift models:
4. Remove the deck lift lever grip. See Figure 4.18.
NOTE: A blow-gun with air pressure regulated to
less than 25 PSI (1.72 Bars), may be
inserted into the small hole at the end of a
rubber grip to inflate it slightly, easing
removal.
On electric deck lift models:
4. Remove the screw that holds the deck cutting
height lever to the shaft using a T40 torx driver.
5. Pull the cutting height lever off of the shaft.
6. Disconnect the deck lift switch.
32
Figure 4.17
Grip
Figure 4.18
Screw
Figure 4.19