Table of Contents
Advertisement
for all moving parts to stop before leaving the
operating position.
3.
Loosen the jam nut on the stop bolt for the
traction pedal
(Figure
Figure 50
1. Traction pedal
2. Stop bolt with jam nut
(forward)
4.
Adjust the stop bolt all the way in (away from
the traction pedal).
5.
Using your hand, push the traction pedal all the
way forward, with light pressure, until it stops
and hold it there.
Note:
Maintain only light pressure on the pedal
when pushing it to the full forward position.
6.
With the seat in the raised position, verify that
you are not over loading the linkage by making
sure the transmission does not move when you
press the pedal to the stop.
7.
Adjust the stop bolt out (toward the traction
pedal) until there is a gap of 1.5 mm (0.060
inch) between the head of the stop bolt and the
bottom of the traction pedal.
8.
Tighten the jam nut to secure the stop bolt in
place.
9.
To change the reverse speed, you can adjust
the reverse stop bolt. To increase the reverse
speed, adjust the stop bolt in; to decrease the
reverse speed, adjust the stop bolt out.
50).
g014893
3. 1.5 mm (0.060 inch)
4. Stop bolt with jam nut
(reverse)
Hydraulic System
Maintenance
Hydraulic System Safety
•
Seek immediate medical attention if fluid is injected
into skin. Injected fluid must be surgically removed
within a few hours by a doctor.
•
Ensure that all hydraulic-fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
•
Keep your body and hands away from pinhole
leaks or nozzles that eject high-pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
Hydraulic Fluid
Specification
The reservoir is filled at the factory with
high-quality tractor transmission/hydraulic fluid. The
recommended replacement fluid is as follows:
Toro Premium Transmission/Hydraulic Tractor
Fluid (Available in 19 L (5 gallon) pails or 208 L (55
gallon) drums. See the Parts Catalog or your Toro
Distributor for part numbers).
Alternate fluids: If the Toro fluid is not available,
Mobil® 424 hydraulic fluid may be used.
Note:
Toro will not assume responsibility for damage
caused by improper substitutions.
Many hydraulic fluids are almost colorless, making
it difficult to spot leaks. A red dye additive for the
hydraulic system oil is available in 20 ml (2/3 fl oz)
bottles. One bottle is sufficient for 15 to 22 L (4 to 6
US gallons) of hydraulic fluid. Order Part No. 44-2500
from your authorized Toro distributor.
Checking the Hydraulic
System
Service Interval: Before each use or daily
1.
Park the machine on a level surface, release the
traction pedal to the N
the engine.
2.
Run the engine at the lowest possible speed to
purge the system of air.
51
position, and start
EUTRAL
Advertisement
Table of Contents
