Cab Controls - Toro Groundsmaster 31223TE Operator's Manual

Diagnostic Ace Display
The machine comes with an electronic controller
which controls most of the machine functions. The
controller determines what function is required for
various input switches (e.g., seat switch and key
switch) and turns on the outputs to actuate solenoids
or relays for the requested machine function.
For the electronic controller to control the machine as
desired, each of the input switches, output solenoids,
and relays must be connected and functioning
properly.
Use the Diagnostic ACE display tool and the overlay
to help verify and correct electrical functions of the
machine. Contact your authorized Toro distributor for
assistance.

Cab Controls

Model with Cab Only
1. Fan control
2. Temperature control
3. Windshield-wiper switch
Air-Recirculation Control
Sets the cab to either recirculate the air in the cabin or
to draw air into the cabin from outside
•
Set it to recirculate the air when using the
air-conditioning.
•
Set it to draw air in when using the heater or fan.
Fan-Control Knob
Rotate the fan-control knob to regulate the speed of
the fan (Figure 11).
Temperature-Control-Knob
Rotate the temperature-control knob to regulate the
air temperature in the cab
Figure 11
4. Air-conditioning switch
5. Air-recirculation control
(Figure
(Figure 11).
Windshield-Wiper Switch
Use this switch to turn the wind shield wipers on or
off (Figure 11).
Air-Conditioning Switch
Use this switch to turn the air conditioning on or off
(Figure 11).
Windshield Latch
Lift up the latch to open the windshield
Press in the latch to lock the windshield in the open
position. Pull out and down on the latch to close and
secure the windshield.
1. Windshield latch
g198816
Rear Window Latch
Lift up the latches to open the rear window. Press in
on the latch to lock the window in
out and down on the latch to close and secure the
window (Figure
Important:
the hood or damage may occur to the hood or rear
window.
11).
18
Figure 12
OPEN
12).
Close the rear window before opening
(Figure 12).
g196911
position. Pull