Table of Contents
Advertisement
you, press the foot pedal and release it when the
steering wheel reaches the desired operating position.
Parking Brake
To engage the parking brake, push down on the brake
pedal and press the top forward to latch it
7). To disengage the parking brake, press the brake
pedal until the parking-brake latch retracts.
Key Switch
The key switch has 3 positions: O
and S
(Figure
8).
TART
1. Power-takeoff (PTO)
switch
2. Oil-pressure-warning light
3. Charge-indicator light
4. Hour meter
5. Differential-lock switch
(2-wheel-drive only)
6. Steering-selector switch
(4-wheel-drive only)
7. Throttle lever
Power-Takeoff (PTO) Switch
The power-takeoff (PTO) switch starts and stops the
attachment
(Figure
8).
Fuel Gauge
The fuel gauge
(Figure
remaining in the fuel tank.
(Figure
, O
/P
FF
N
REHEAT
Figure 8
8. Diagnostic light
(4-wheel-drive only)
9. Key switch
10. Power point
11. Optional switch location
12. Deck-lift switch
13. Glow-plug light
14. Coolant-temperature-warning
light
9) indicates the amount of fuel
,
1. Fuel gauge
Throttle Lever
The throttle lever
speed. Moving the throttle lever forward toward the
F
position increases the engine speed. Moving
AST
it rearward toward the S
engine speed. The throttle controls the speed of the
PTO and, with the traction pedal, controls the ground
speed of the machine. Always run the machine
with the throttle in the F
attachments.
Hour Meter
g014169
The hour meter records the number of hours that
you operate the machine with the key switch in the
R
position. Use these times for scheduling regular
UN
maintenance.
Engine-Coolant-Temperature
Warning Light
If the engine-coolant temperature is high, the warning
light
(Figure
8) glows and an equipped attachment
shuts off. If the coolant temperature rises another
11°C (20° F) while you continue to operate the
machine, the engine shuts off.
Important:
If the attachment shuts off and the
temperature warning light is on, push the PTO
knob down, drive the machine to a safe, flat area,
move the throttle lever to the S
the traction pedal to move to the N
and engage the parking brake. Allow the engine
to idle for several minutes while it cools to a safe
level. Shut off the engine and check the cooling
system; refer to
(page
47).
16
Figure 9
2. Fuel-tank cap
(Figure
8) controls the engine
position decreases the
LOW
position when operating
AST
position, allow
LOW
EUTRAL
Checking the Cooling System
g014170
position,
Advertisement
Table of Contents
