Table of Contents
Advertisement
Changing to Machine Operation
1.
Rotate each bypass valve clockwise 1 turn and
hand tighten them
Note:
Do not overtighten the bypass valves.
2.
Torque the valves approximately 8 N∙m (71 in-lb)
as shown in
Figure
Note:
The machine does not drive unless the bypass
valves are turned in.
Figure 26
1. Bypass valves
Hauling the Machine
•
Remove the key and shut off the fuel (if equipped)
before storing or transporting the machine.
•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
(Figure
26).
26.
Locating the Tie-Down
Points
There are tie downs located at the front and rear sides
of the machine
Note:
Use properly-rated DOT-approved straps in 4
corners to tie down the machine.
•
2 on the front of the operator's platform
•
Rear tire
g014270
1. Front tie-down point
31
(Figure
27).
Figure 27
2. Rear tie-down point
g014264
Advertisement
Table of Contents
