Table of Contents
Advertisement
•
Keep your hands and feet away from rotating
parts. Keep clear of the discharge opening.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Stop the blades whenever you are not mowing.
•
Stop the machine, remove the key, and wait for
all moving parts to stop before inspecting the
attachment after striking an object or if there is
an abnormal vibration in the machine. Make all
necessary repairs before resuming operation.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
•
Disengage the drive to the cutting unit, shut
off the engine, remove the key, and wait for all
moving parts to stop before adjusting the height of
cut (unless you can adjust it from the operating
position).
•
Operate the engine only in well-ventilated areas.
Exhaust gases contain carbon monoxide, which
is lethal if inhaled.
•
Never leave a running machine unattended.
•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage the power takeoff and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lightning.
•
Do not use the machine as a towing vehicle.
•
Use accessories, attachments, and replacement
parts approved by Toro only.
Rollover Protection System
(ROPS) Safety
•
The ROPS is an integral and effective safety
device.
•
Do not remove any of the ROPS components from
the machine.
•
Ensure that the seat belt is attached to the
machine.
•
Pull the belt strap over your lap and connect the
belt to the buckle on the other side of the seat.
•
To disconnect the seat belt, hold the belt, press
the buckle button to release the belt, and guide the
belt into the auto-retract opening. Ensure that you
can release the belt quickly in an emergency.
•
Check carefully for overhead obstructions and do
not contact them.
•
Keep the ROPS in safe operating condition by
thoroughly inspecting it periodically for damage
and keeping all the mounting fasteners tight.
•
Replace damaged ROPS components. Do not
repair or alter them.
Additional ROPS Safety for
Machines with a Foldable Roll Bar
•
Keep a folding roll bar in the raised and locked
position, and wear your seat belt when operating
the machine with the roll bar in the raised position.
•
Lower a folding roll bar temporarily only when
necessary. Do not wear the seat belt when the
roll bar is folded down.
•
Be aware that there is no rollover protection when
a folded roll bar is in the down position.
•
Check the area that you will be mowing and never
fold down a folding roll bar in areas where there
are slopes, drop-offs, or water.
Additional ROPS Safety for
Machines with a Cab or a Fixed
Roll Bar
•
A cab installed by Toro is a roll bar.
•
Always wear your seat belt.
Slope Safety
•
Slopes are a major factor related to loss of control
and rollover accidents, which can result in severe
injury or death. You are responsible for safe slope
operation. Operating the machine on any slope
requires extra caution.
•
Evaluate the site conditions to determine if the
slope is safe for machine operation, including
surveying the site. Always use common sense
and good judgment when performing this survey.
•
Review the slope instructions listed below for
operating the machine on slopes and to determine
whether you can operate the machine in the
conditions on that day and at that site. Changes
in the terrain can result in a change in slope
operation for the machine.
•
Avoid starting, stopping, or turning the machine on
slopes. Avoid making sudden changes in speed or
direction. Make turns slowly and gradually.
•
Do not operate a machine under any conditions
where traction, steering, or stability is in question.
25
Advertisement
Table of Contents
