Removing The Transport Fasteners And Protective Covers - Huawei FusionCol8000-E140 Quick Manual

FusionCol8000-E140 Modular Indirect Evaporative
Cooling System
Quick Guide (2021, Ireland)
Figure 1-19 Requirements for wrapping the electric heating belt
● The temperature control switch is integrated with the electric heating belt. The
electric heating belt needs to be wrapped around the drainpipe and water refill
pipe evenly during onsite installation. The rear of the thermal switch must be
attached to the drainpipe and water refill pipe.
● Wrap the electric heating belt and then wrap the thermal insulation foam.
Ensure that the thermal insulation foam covers the temperature control switch
and electric heating belt. The thermal insulation foam must withstand a
temperature above 200°C.

1.3.7 Removing the Transport Fasteners and Protective Covers

Procedure
Step 1 Take out the desiccant bag behind No. 2 maintenance door.
●
●
●
Issue 02 (2023-08-03)
NO TICE
When entering the No. 2 maintenance door, lift the pedal fastener and slowly
put down the pedal.
Take out the desiccant bag behind No. 2 maintenance door.
Turn up the pedal and secure it.
Copyright © Huawei Digital Power Technologies Co., Ltd.
1 System Installation
22