Toshiba AW-G9930S Service Manual page 38

Check the washing amount sensor
In case of adjusting or replacing the electric timer. belt or drive assembly, check the washing
amountsensor in the following steps.
<Procedures>
(1) Check to see that no water or clothes remaining in the tub. (If something remains in the tub, it may cause
faulty result.)
(2) Connect the power plug.
(3) Turn on POWER SWITCH with WASH and WATER LEVEL buttons kept pressing.
(4) Press START button.
Condition
1 Normal
condition
2 Belt,
Belt tension
3 Connector of
the program timer
If the condition is 2 - 3, continue the steps until it becomes 1 (normal).
*
All manuals and user guides at all-guides.com
Action
After detecting the washing amount sensor
starts, the power is turned off automatically.
After running, "00" is indicated on the numeral
LED.
After running, "FF" is indicated on the numeral
LED and alarm buzzers.
– 37 –
Remedy
Leave the machine as it is,
*
because the belt tension is
normal.
Check to mount the belt.
*
Turn the power off and correct
*
the belt tension.
Check the belt tension again.
*
Check to contact the each
*
connector of the program
timer.
Check the belt tension again.
*