Toshiba AW-G9930S Service Manual page 32

Parts
(12) Drive assembly
* Follow the reverse order of removal.
Note 1 : Be careful not to let matter such as
Note 2 : When fitting the clutch spring onto the
Note 3 : After assembling, adjust the gap
Note 4 : When the drain valve motor is turned
Note 5 : After assembling, wipe clean any oil
Note 6 : After completing replacement of the
Note 7 : When assembling the clutch spring with
Note 8 : When removing the mechanism section
x Before starting washing, open the faucet and check that the water supply hose joint is
not loose and no water leaks.
The loose screw or hose joint may cause water leakage resulting in an unexpected damage.
WATER LEAKAGE
All manuals and user guides at all-guides.com
Procedure ( : Notes)
grease or oil adhere to the surface of the
brake drum. Wipe clean if a foreign
matter is clogged. If left on, brake
performance will be poor, and unusual
noises may occur.
spin shaft, check the amount of grease
and apply grease to the inner surface if
insufficient (Sunlight Lithium EM-3).
between the tip of the clutch lever
adjustment screw and the brake lever to
0.5 - 1.5 mm. (Fig. 8)
ON, the catches on the clutch lever
schould separate from the sleeve,
leaving a gap of over 1.5 mm. (Fig.8)
adhering to the pulleys or other parts.
bearing mechanism, be sure to fill with
water and confirm the absence of water
leaks.
the sleeve assy, securely hook the catch
on the sleeve assy by deforming the
clutch spring. (Fig. 10)
or checking to see whether screws are
loosened, always remove the wash tub
(spin basket). If not, the wash tub (spin
basket) may be inclined.
CAUTION
– 31 –
Illustrations
Clutch lever
adjusting screw
Brake lever
0.5 ~ 1.5 mm
Clutch lever
(Fig. 8)
More than
1.5 mm
Clutch lever
Sleeve of the
clutch spring
Cap 2
Rubber ring
(Fig. 9)
Short
Clutch
spring
Hook the catch
(Fig. 10)
Long
deforming
Catch
Sleeve
assembly