Toshiba AW-G9930S Service Manual page 29

Parts
1) Remove the rear lid (6 screws).
(8) Motor
2) Remove wire harness from the cord clamper
(1 screw) and remove the lead wire bundle.
Then take off vinyl tape and disconnect the
enclose connector of lead wires on the
motor.(Photo. 13 and 14)
3) Lay down the machine with the front side
down.
4) Remove 2 tapping screws (size 10 mm) and
remove the packing bracket. (Use ϕ 5 - ϕ 6
double mouth box wrench. Service part No.
42T29008 is provided.)
(Photo. 15)
5) Remove the V-belt.
6) Remove 1 mounting screw from the lead
path hole and remove the leads (ϕ 5 tapping
screw).
(Photo. 15)
7) Loosen the motor pulley nut and bolt, and
remove the motor pulley from the motor.
8) Loosen 4 hex. bolts (size 10 mm) and
remove motor from the motor mounting
base.
(Photo. 16)
* Follow the reverse order of removal.
Note 1 : Mount the motor so that the V-belt of
Note 2 : Insert motor lead wires securely into the
x Unplug the power cord for the work
unnecessary to power on like disassem-
bling. Do not hold the plug by a wet hand.
Failing to unplug may cause an electric shock.
UNPLUG POWER
All manuals and user guides at all-guides.com
Procedure ( : Notes)
8 - 10 mm bending is obtained when
2 kg force is applied at the belt position
shown in Fig. 7.
valve lead path hole.
WARNING
– 28 –
Illustrations
(Photo. 13)
(Photo. 14)
(Photo. 15)
(Photo. 16)
Motor shaft
Motor pulley
2 kg
Bend
8~10 mm
(Fig. 7)
Drive
shaft
Pulsator
pulley