Bleeding Air from the Injectors (continued)
Fuel injectors
4. Move the throttle to the F
5. Turn the key to the S
key to the O
To prevent overheating of the starter motor, do not engage the starter for longer than
15 seconds. After 10 seconds of continuous cranking, wait 60 seconds before
engaging the starter motor again.
6. Tighten the tube nut securely.
7. Clean any fuel from the engine.
8. Repeat steps
9. Start the engine, check for leaks, and shut off the engine.
Note:
10. Close and latch the hood.
Electrical System Maintenance
Servicing the Battery
Battery electrolyte contains sulfuric acid, which is lethal if consumed and causes
severe burns.
• Do not drink electrolyte and avoid contact with skin, eyes, or clothing.
• Wear safety glasses and rubber gloves.
• Fill the battery where clean water is always available for flushing the skin.
Maintenance: Electrical System Maintenance
AST
position and watch the fuel flow around the connector. Turn the
TART
position when there is a continuous flow.
FF
3
through
7
for the remaining fuel-injector nozzles.
Repair all fuel leaks.
G415052
position.
IMPORTANT
DANGER
Page 6–20
3466-297 A