Storage; Cleaning And Storing The Machine - Toro Z Master 8000 Series Operator's Manual

Storage

Cleaning and Storing the
Machine
1. Disengage the power takeoff (PTO), engage the
parking brake, shut off the engine, and remove
the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean dirt and
chaff from the outside the engine cylinder head
fins and blower housing.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
engine, hydraulic pumps, and motors.
3. Check the brake; refer to
Brake (page 46).
4. Service the air cleaner; refer to
Cleaner (page 34).
5. Grease the machine; refer to
31).
6. Change the crankcase oil; refer to
Engine Oil (page
7. Check the tire pressure; refer to
Tire Pressure (page
8. Change the hydraulic filters; refer to
the Hydraulic Filter (page
9. Charge the battery; refer to
(page 41).
10. Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
Note:
Run the machine with the blade-control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
11. Check the condition of the blades; refer to
Inspecting the Blades (page
12. For storage over 30 days, prepare the machine
as follows:
A. Add a petroleum-based
stabilizer/conditioner to fuel in the
tank. Follow the mixing instructions from
the stabilizer manufacturer. Do not use
an alcohol-based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
Adjusting the Parking
Servicing the Air
Lubrication (page
Changing the
36).
Checking the
44).
Replacing
55).
Charging the Battery
56).
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Shut off the engine, wait for it to cool, and
drain the fuel tank; refer to
Fuel Tank (page
D. Start the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per
local codes.
Important:
stabilizer/conditioner over 90 days.
13. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or
storage area.
16. Remove the key from the ignition switch
and keep it out of reach of children or other
unauthorized users.
17. Cover the machine to protect it and keep it clean.
62
Servicing the
39).
Do not store fuel with