Maintenance; Recommended Maintenance Schedule(S) - Toro Z Master 8000 Series Operator's Manual

Maintenance

Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 50 hours
After the first 100 hours
Before each use or daily
Every 40 hours
Every 100 hours
Every 150 hours
Every 160 hours
Every 200 hours
Every 250 hours
Every 500 hours
Every 2,000 hours
Monthly
Maintenance Procedure
• Change the oil in all 3 gearbox housings and add oil as needed.
• Check the wheel-lug nut torque.
• Check the wheel-hub nut torque.
• Check the parking brake adjustment.
• Change the hydraulic filter and reservoir hydraulic fluid when using any type of fluid.
• Check the safety-interlock system.
• Grease the front caster wheel hubs (more often in dirty or dusty conditions).
• Check the engine-oil level.
• Clean the engine screen and the oil cooler.
• Clean the hydraulic pumps.
• Check the mower blades.
• Clean the mower deck.
• Clean debris from the machine.
• Grease the drive shaft (more often in dirty or dusty conditions).
• Check the tire pressure.
• Inspect the belts for cracks and wear.
• Check the hydraulic fluid level.
• Grease the mower-deck flip-up pivot (more often in dirty or dusty conditions).
• Grease the mower-deck push-arm tubes (more often in dirty or dusty conditions).
• Check the oil in all 3 gearbox housings and add oil as needed.
• Change the engine oil (more often in dirty or dusty conditions).
• Clean the engine-oil cooler.
• Check and clean engine cooling fins and shrouds.
• Inspect the primary filter and air-inlet screen.
• Lubricate the brake-handle pivot.
• Lubricating the brake-rod bushings and steering linkage rod ends.
• Change the engine oil filter.
• Replace the fuel filter (more often in dirty or dusty conditions).
• Replace the primary air filter (more often in dusty or sandy conditions).
• Check the safety air filter.
• Change the hydraulic filter and reservoir hydraulic fluid when using Mobil® 1 fluid
(more often in dirty or dusty conditions).
• Replace the safety air filter.
• Check and gap the spark plug.
• Check the wheel-lug nut torque.
• Check the wheel-hub nut torque.
• Adjust the caster-pivot bearings.
• Check the parking brake adjustment.
• Change the hydraulic filter and reservoir hydraulic fluid when using Toro®
HYPR-OIL™ 500 hydraulic fluid (more often in dirty or dusty conditions).
• Change the oil in all 3 gearbox housings and add oil as needed.
• Check the battery.
29