Figure 25
1. Bolt and pin
Adjusting the Height of Cut
The cutting height of the mower deck is adjusted from
2.5 to 10.2 cm (1 to 4 inches) in 6.3 mm (1/4 inch)
increments.
1. Move the speed-control lever to the N
position to stop the machine.
2. Disengage the PTO, engage the parking brake,
shut off the engine, and wait for all moving parts
to stop.
3. Using the mower-deck handle, raise the mower
g034253
deck, and move the cotter pins to the desired
height-of-cut position. Repeat for the opposite
side.
1. Cotter pin
Stopping the Machine
1. Pull the speed-control lever back to the N
position, disengage the PTO-engagement lever,
and turn the ignition key to the O
2. Engage the parking brake when you leave the
machine; refer to
(page
22).
3. Remove the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and engage
the parking brake when leaving the machine
unattended, even if just for a few minutes.
25
EUTRAL
g025067
Figure 26
2. Mower-deck handle
position.
FF
Engaging the Parking Brake
1
2
g025067
EUTRAL