Raising/Lowering The Seat - Toro Groundsmaster 360 Operator's Manual

driver's weight and the seat must be checked and
adjusted before the machine is operated.
Note:
To avoid compressor damage during weight
adjustment, the compressor must be operated no
longer than 1 minute.
Changing the Seat Position
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1. To adjust, lift the lever to unlock the seat
18).
2. Slide the seat to the desired position and release
lever to lock in position.
3. Verify that the seat has locked into place by
attempting to move it back and forth.
Note:
Do not operate the locking lever while
operating the machine.
Changing the Lumbar Support
The lumbar support increases both the seating
comfort and the performance of the driver.
The back of the seat can be adjusted to provide a
customized lumbar support for your lower back.
By turning the adjustment knob upwards, the
curvature in the upper part of the backrest cushion
can be adjusted. By turning the knob downwards, the
curvature in the lower part of the backrest cushion can
be adjusted (Figure 18).
0 = No curvature
1 = Maximum curvature at the top
2 = Maximum curvature at the bottom
Adjusting the Armrests
The armrests can be folded back if required and the
height individually adjusted.
To adjust the armrests for height, separate the round
cap (Figure 18) from the cover, loosen the hexagon
nut (13 mm) behind it and adjust the armrests to the
desired position and tighten the nut. Replace the cap
onto the nut.
WARNING
Do not install the armrest in the lowest
position as the seat belt roller might not
function properly.
Changing the Armrest Angle
The angle of the armrests can be adjusted for operator
comfort.
To adjust the angle of the armrests, turn the
adjustment knob
When turning the knob to the outside (+) the front part
of the armrest will be lifted, when turning the knob to
inside (-) it will be lowered.
Changing the Backrest Position
(Figure
The back of the seat can be adjusted to provide a
more comfortable ride. Position the back of the seat
where it is most comfortable.
Pull up the locking lever to release the backrest catch
(Figure 18). When releasing the backrest catch, do
not apply load to the backrest by pressing against it.
By exerting pressure on or off the front or rear of the
seat it can be moved to the desired position. Release
the locking lever to lock the backrest.
Note:
The backrest should not be able to move the
into another position after it has been locked.

Raising/Lowering the Seat

To access the hydraulic and other systems under
the seat, you need to unlatch the seat and swing it
forward.
1. Move the seat latch, located on the left side of
the seat, rearward to unlatch the seat and pull
forward on the top of the seat
1. Seat latch
2. To lower the seat, pull up on the seat latch
release bar and lower the seat into the locked
position.
26
(Figure 18).
(Figure
Figure 19
19).
g014174