Product Overview; Controls - Toro Groundsmaster 360 Operator's Manual

Product Overview

Controls

Become familiar with all the controls before you start
the engine and operate the machine.
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. Ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the Fast position.
To stop, reduce foot pressure on the traction pedal
and allow it to return to the center position.
1. Parking brake
2. Brake pedal
3. Tilt steering pedal
Mow Speed Limiter
The mow speed limiter lever
forward to limit the traction speed while operating.
Brake Pedal
The brake pedal is used in conjunction with the brake
pedal latch to engage and disengage the parking
brake (Figure 3) To stop the machine, release the
traction pedal and allow it to return to the center
position. The brake can assist in stopping in an
emergency situation.
3) controls the forward and
Figure 3
4. Traction pedal
5. Mow speed limiter
(Figure 3) can be flipped
Parking Brake
To engage the parking brake, push down on the brake
pedal and press the top forward to latch
release the parking brake, press the brake pedal until
the parking brake latch retracts.
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal down, and pull the steering tower toward you to
the most comfortable position and then release the
pedal (Figure 3).
Engine Speed Switch
The engine speed switch
to change the engine speed. By momentarily tapping
the switch, the engine speed can be increased or
decreased in 100 rpm increments. By holding the
switch down the engine will automatically move to
High or Low idle, depending on which end of the
switch is depressed.
1 2
7 6
g014168
1. InfoCenter
2. Power take off (PTO)
Switch
3. Engine speed switch
4. Steering selector switch
InfoCenter
The InfoCenter LCD display shows information about
your machine such as the operating status, various
diagnostics and other information about the machine
(Figure 4).
Ignition Switch
The ignition switch has three positions: Off,
On/Preheat, and Start
13
(Figure
(Figure 4) has two modes
3 4
5
Figure 4
5. Power point
6. Ignition switch
7. Deck lift switch
(Figure 4).
3). To
G026098
g026098