Think Safety First; Starting And Stopping The Engine - Toro Groundsmaster 360 Operator's Manual

Adding Fuel
1. Park the machine on a level surface.
2. Shut off the engine and set the parking brake.
3. Clean around the fuel tank cap and remove the
cap (Figure 11).
1. Fuel gauge
2. Fuel-tank cap
Important:
Do not open the fuel tank when
parked on a hill. The fuel could spill out.
4. Add fuel to the fuel tank, until the level is even
with the bottom of the filler neck. Do not over
fill the fuel tank.
5. Install the fuel tank cap and secure. Wipe up
any fuel that may have spilled.
Note:
If possible, fill the fuel tank after each use.
This will minimize possible buildup of condensation
inside the fuel tank.
Figure 11

Think Safety First

Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
DANGER
Operating on wet grass or steep slopes can
cause sliding and loss of control.
Wheels dropping over edges can cause
rollovers, which may result in serious injury,
death or drowning.
Always use the seat belt when operating the
machine.
Read and follow the rollover protection
instructions and warnings.
To avoid loss of control and possibility of
g014170
rollover:
• Do not operate near drop-offs or near
water.
• Reduce speed and use extreme caution on
slopes.
• Avoid sudden turns or rapid speed
changes.
CAUTION
This machine produces sound levels in
excess of 85 dBA at the operators ear and can
cause hearing loss through extended periods
of exposure.
Wear hearing protection when operating this
machine.
Starting and Stopping the
Engine
Starting the Engine
1. Raise the roll bar up and lock it into place, sit on
the seat, and fasten the seat belt.
2. Make sure the traction pedal is in the neutral
position.
3. Set the parking brake.
4. Move the PTO (power take off) switch to the off
position (Figure
21
12).