Driving The Machine; Steering Selection - Toro Groundsmaster 360 Operator's Manual

1. InfoCenter
2. Power take off switch
(PTO)
5. Turn the ignition key clockwise to the Run
position.
The InfoCenter glow plug icon will turn on for
6 seconds.
6. After the InfoCenter glow plug icon goes out,
turn the key to the Start position. When the
engine starts release the key.
Important:
Use starting cycles of no
more than 15 seconds per minute to avoid
overheating the starter motor.
Note:
Additional starting cycles may be
required when starting the engine for the first
time after the fuel system has been completely
drained.
Important:
When engine is started for the
first time, or after an engine oil change, or
an overhaul of the engine, transmission, or
wheel motor, operate the machine with the
engine speed switch in the Slow position
in both the forward and reverse directions
for one to two minutes. Also operate the
lift switch and PTO switch to ensure proper
operation of all parts. Then shut the engine
off and check fluid levels, check for oil
leaks, loose parts, and any other noticeable
malfunctions.
CAUTION
Shut the engine off and wait for all
moving parts to stop before checking
for oil leaks, loose parts, or other
malfunctions.
Stopping the Engine
1. Disengage the PTO, make sure the traction
pedal is in the neutral position, set the parking
Figure 12
3. Ignition switch
4. Engine speed switch
brake, and move the engine speed switch to the
idle position.
2. Let the engine idle for 60 seconds.
3. Turn the ignition key to the Off position. Wait
for all moving parts to stop before leaving the
operating position.
4. Remove the key before transporting or storing
machine.
Important:
g026090
the fuel pump or accessories may run and
g026090 cause the battery to lose charge.
Children or bystanders may be injured
if they move or attempt to operate the
tractor while it is unattended.
Always remove the ignition key and
set the parking brake when leaving the
machine unattended, even if just for a
few minutes.

Driving the Machine

The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the Fast position for best
performance. Always operate in the Fast throttle
position when mowing.

Steering Selection

For maximum trimming and minimum turf damage
the machine should always be operated in 4 wheel
steering. However, when it is desired to transport
the machine on roads or trails, the machine can be
switched into 2 wheel steering.
1. Steering selector switch
22
Make sure to remove the key as
CAUTION
Figure 13
g026089
g026089