Drive System Maintenance; Checking The Drive Tire Air Pressure; Checking The Wheel Hub Bolts - Toro 29516 Operator's Manual

24in stand-on aerator
Hide thumbs Also See for 29516:
Table of Contents

Advertisement

5.
Remove the screw, washer, and ground cable
from the engine. Connect the negative battery
cable.
Note:
If time does not permit charging the
battery or if charging equipment is not available,
connect the negative battery cables and run
the vehicle continuously for 20 to 30 minutes to
charge the battery.
Drive System
Maintenance
Checking the Drive Tire Air
Pressure
Service Interval: Every 50 hours
Note:
You do not adjust air pressure for the
semi-pneumatic caster tires.
1.
Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
2.
Check the air pressure of the drive tires.
3.
Adjust the air pressure in the drive tires to 152
to 165 kPa (22 to 24 psi).
Checking the Wheel Hub
Bolts
Service Interval: Yearly
Torque the wheel hub bolts
N∙m (27 to 33 ft-lb).
Note:
Do not use anti-seize compound on the wheel
hub.
1. Lug nut
38
(Figure
43) to 37 to 45
Figure 43
2. Hub bolt
g249686

Advertisement

Table of Contents
loading

Table of Contents