Toro 29516 Operator's Manual page 33

Changing the Engine Oil
Service Interval: After the first 5 hours
Every 100 hours (more often under severe
conditions.)
Note:
Dispose of the used oil at a recycling center.
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil
drains completely.
2. Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Change the engine oil as shown in
Note:
Torque drain plug to 18 N∙m (13 ft-lb).
Figure 36
4. Slowly pour approximately 80% of the specified
oil into the filler tube, and slowly add the
additional oil to bring it to the Full mark
37).
Figure 36.
5. Start the engine and drive to a flat area.
6. Check the engine-oil level.
7. Reset the engine-oil service reminder; refer to
Resetting the Engine-Oil Maintenance Reminder
(page
Resetting the Engine-Oil
Maintenance Reminder
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
Note:
reset the maintenance reminder.
2. Cycle the key switch between the
and the
The Service Engine screen displays and flashes
(Figure
g249685
(Figure
3. Press down the multi-function switch.
The engine-oil maintenance reminder resets to
100.0 (hours), exits the Service Engine screen,
and returns to the default screen.
33
Figure 37
33).
You must engage the parking brake to
position 4 times within 8 seconds.
OFF
38).
Figure 38
Service Engine Screen
g249684
30).
position
RUN
g212117