Table of Contents
Advertisement
Figure 54
1. Filter (auxiliary-hydraulic system)
2.
Apply a thin coat of the specified hydraulic fluid
to the rubber seal of the new filter; refer to
Auxiliary Hydraulic Fluid Specification (page
3.
Turn the filter clockwise until rubber seal
contacts the filter adapter, then tighten the filter
an additional 2/3 to 3/4 turn
Adding Auxiliary Hydraulic Fluid
1.
Remove the cap and check the hydraulic-fluid
level in the reservoir.
2.
Add the specified hydraulic fluid until the level
reaches the FULL COLD line located on the
reservoir tank; refer to
Fluid Specification (page 42)
Auxiliary Hydraulic Fluid Level (page
Note:
If the fluid is at ambient-air temperature,
about 24°C (75° F), fill only to the FULL COLD
level.
3.
Install the hydraulic reservoir cap and tighten it
until snug.
Note:
Do not overtighten the reservoir cap.
4.
Start the engine and raise and lower the tines.
Lower the tines to the ground and refill the
reservoir to the FULL COLD line.
5.
Check the fluid level again; repeat steps
through
5
until the level does not decrease.
g268752
42).
(Figure
54).
Auxiliary Hydraulic
and
Checking the
42).
2
Transmission Fluid
Specification
Transmission fluid type: Toro® Hypr-Oil™ 500 or
Mobil® 1 15W-50 synthetic motor oil.
Important:
Use the specified fluid. Other fluids
could cause system damage.
Checking the Transmission
Fluid Level
Service Interval: Every 50 hours
1.
Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
2.
Allow the machine to cool.
3.
Remove the cap from the expansion tank and
check the transmission-fluid level in the tank
(Figure
55).
Note:
The transmission fluid level should cover
the FULL COLD fill line molded into the side of
the tank.
1. Cap
2. Filler neck (expansion
tank)
4.
If necessary, add the specified transmission fluid
until the fluid level is at the FULL COLD fill line
of the expansion tank
5.
Install the expansion tank cap and tighten it until
snug.
Important:
Do not overtighten the expansion
tank cap.
44
Figure 55
3. FULL COLD line
(Figure
55).
g249697
Advertisement
Table of Contents
