Fujitsu AIRSTAGE J-II Design & Technical Manual page 634

FUNCTION SETTING
„ „
4) Pressing the SET TEMP. p button or SET TEMP. q button, select a remote controller
address (select the indoor unit you want to operate).
5) Press the FAN button so that the "Function number" display flashes. Then, press either the
SET TEMP. p button or the SET TEMP. q button to set up the function number.
6) Press the FAN button so that the "Setting number" display flashes. Then, press either the
SET TEMP. p button or the SET TEMP. q button to set up the setting number.
7) Pressing the START/STOP button, confirm the setting.
(The data will be transferred to the indoor unit.)
● When the data was not set up on the indoor
unit (-- is displayed.)
● Set up the data again according to the
procedure in step 5), 6) above.
FUNCTION DETAILS
„ „
Refer to 2-8. FUNCTION DETAILS.
Remote controller address
Ex.) When remote controller address "01" is selected
Function number
Setting number
Ex.) Function number : 30, Setting number : 01
ERROR
When the data was normally set up on the indoor
unit.
- (07-108) -
GOOD