Fujitsu AIRSTAGE J-II Design & Technical Manual page 413

 To protect the compressor of the outdoor unit, carefully read and understand the following cautions that may affect
the operation of the compressor before executing the setting.
 When performing periodical settings like schedule settings for the following functions, perform the setting to all the
„
indoor units in the same refrigerant system simultaneously, conforming to the timing restriction described below.
<Corresponding function>
· Start operation
· Release indoor unit forced
thermostat off mode
 Forced thermostat OFF instruction
 Only one equipment can send these instructions for each refrigerant system.
„
 When these instructions are sent by multiple equipment, the system may not respond as instructed or may
„
malfunction.
SPECIFICATIONS
„ „
Power supply
Input Power (W)
Dimensions [H × W × D] (mm)
Weight (g)
Operating environment
z „
Temperature(°C)
Humidity (%)
Transmission specifications
z „
Transmission speed
Transceiver
Transmission form
Cable
Network connector
Terminal resistor
More than 10 minutes must elapse
More than 10 minutes must elapse
1ø AC 208-240 V 50/60 Hz
Operating
Packaged
Packaged
No condensation
L W ® network
ON ORKS
78 kbps
®
FT-X1 (Echelon Corporation)
Free topology
Twisted pair cable (shield)
22AWG equivalent
One terminal
None attachment (It attaches at the terminal of a network.)
- (05 - 109) -
· Stop operation
· Set indoor unit forced thermostat
off mode
4.5
67 × 288 × 211
1500
0 to 46
-10 to 60
0 to 95 (RH) ;