Table of Contents
Advertisement
Operation status
Standby mode
Online mode
Battery mode
1 beep every 10 seconds
End of backup time
1 beep every 3 seconds
High Efficiency mode
Bypass mode
Display functions
Press the Enter ( ) button to activate the menu options. Use the two middle buttons (
through the menu structure. Press the Enter (
return to the previous menu.
Cause
The UPS is Off.
The UPS is operating normally.
A utility failure has occurred and the
UPS is on Battery mode.
The UPS is on Battery mode and the
battery packs are running low.
The UPS is operating on High
Efficiency mode.
An overload or a fault has occurred or
a command has been received, and
the UPS is in Bypass mode.
) button to select an option. Press the
Description
Equipment is not powered until power
(
) button is pressed.
The UPS is powering and protecting
the equipment.
The UPS is powering the equipment
with the battery power. Prepare your
equipment for shutdown.
This warning is approximate, and the
actual time to shut down might vary
significantly.
Depending on the UPS load and
number of Extended Battery Modules
(EBMs), the "Battery Low" warning
might occur before the battery packs
reach 20% capacity.
The UPS is powering and protecting
the equipment.
Equipment is powered but not
protected by the UPS.
and
) to scroll
button to cancel or
.
Chapter 2
Presentation
9
Advertisement
Table of Contents
