Storage - Toro 31971 Operator's Manual

Storage

1. Disengage the PTO, release the traction pedal
to the neutral position, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operator's position.
3. Allow the engine to cool before adjusting,
cleaning, storing, or repairing the machine.
4. Thoroughly clean the cutting unit, paying special
attention to these areas:
•
Underneath the cutting unit
•
Under the cutting unit belt covers
•
PTO shaft assembly
•
All grease fittings and pivot points
5. Remove, sharpen, and balance the cutting unit
blades. Install the blades and torque the blade
fasteners to 85 to 110 ft-lb (115 to 149 N∙m).
6. Check all fasteners for looseness and tighten
them as necessary.
7. Grease or oil all grease fittings and pivot points.
Wipe off any excess lubricant.
8. Lightly sand and use touch up paint on painted
areas that are scratched, chipped or rusted.
Repair any dents.
All manuals and user guides at all-guidesbox.com
23