Advertisement
(Note for assembly)
Attach the paper feed roller so that the one-way clutch is on the rear
frame side. (Be careful of the direction.)
Attach the roller holder as shown below.
2. Transport unit
2-1. Resist roller, transfer roller
1
Open the front cover.
2
Release two lock pawls of the TC case, and lift the front side of
the TC case to remove.
3
Remove the hook of the front frame side bearing, and lift it up to
remove it toward the upper frame side. Remove the rear frame
side connector, and slide and remove the resist roller ass'y toward
the rear frame side.
One-way clutch side
4
Remove the clutch and the gears as shown below.
(Note for assembly)
1) Attach so that the resist roller clutch projection is on the paper exit
side as shown in the figure below.
2) Arrange the cable and the power grounding wire from the resist
roller clutch as shown in the figure below.
3) Hook the hook section of the TC case as shown below.
4) When attaching the resist roller ass'y to the copier, attach over the
upper side of the PS roller lower mylar, then rotate the roller to set
the mylar to the normal position. (If the mylar is deformed, it may
cause paper jam. Replace it if deformed.)
PS mylar
6 – 3
TC/SC case
Advertisement
