Table of Contents
Advertisement
Figure 72. Locking the 4-port card into position
5. If necessary, tighten the four captive screws that secure the air dam to the front of the embedded module.
6. Install the SFPs into the embedded module.
Install an embedded module
Steps
1. Align the embedded module with the empty slot and carefully push it into the slot.
As the embedded module is installed, the release lever rotates inward.
Figure 73. Installing the embedded module
2. When the embedded module is fully seated, push the release lever back into the system until the orange tab locks the lever
in place.
Base enclosure service procedures
73
Advertisement
Table of Contents
