Remove The Memory Module; Install The Memory Module - Dell EMC Integrated Data Protection Appliance DP4400 Service Manual

Remove and replace assemblies

Remove the memory module

Install the memory module

Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide
40
The procedure for removing a memory module and NVDIMM-N is identical.
Before you begin
WARNING
Allow the memory modules to cool after you power off the system. Handle the
memory modules by the card edges and avoid touching the components or
metallic contacts on the memory module.
CAUTION
To ensure proper system cooling, memory module blanks must be installed in any
memory socket that is not occupied. Remove memory module blanks only if you
intend to install memory modules in those sockets.
Procedure
1. Locate the appropriate memory module socket.
CAUTION
Handle each memory module only by the card edges, ensuring not to touch
the middle of the memory module or metallic contacts.
2. Push the ejectors outward on both ends of the memory module socket to
release the memory module from the socket.
3. Lift and remove the memory module from the system.
Figure 28 Removing a memory module
The procedure for installing a memory module and NVDIMM-N is identical.
Before you begin
Follow all safety guidelines. Ensure that you where an ESD wrist strap when handling
DIMMs and other internal components.