Figure 172. Installing the bezel
Verify the operation of an added drive
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you added the drive.
3. On the Components card, under Drives, expand ExpansionEnclosure and select the drive.
The status of the drive should read Healthy. If the status is still Faulted, wait a few minutes and refresh PowerStore
Manager. If the status does not change, ensure that the drive is correctly seated, or contact your service provider.
Replace a faulted drive in an NVMe expansion
enclosure
Take the following actions to remove a faulted drive from an NVMe expansion enclosure and install a replacement drive.
Identify a faulted drive from PowerStore Manager
Before you replace a drive, ensure that you have identified its location within the system. Using PowerStore Manager, you can
identify and locate a faulted drive.
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance that includes the drive that you need to replace.
3. On the Components card, under Drives, expand ExpansionEnclosure and select the faulted drive.
Faulted parts appear in red in the image of the system, and report a status of Faulted in the State field.
4. Click Blink LED.
The amber fault light on the drive starts blinking.
CL5262
NVMe expansion enclosure service procedures
143