Table of Contents
Advertisement
Remove a power supply
About this task
The power supplies in the NVMe expansion enclosure are installed upside down.
NOTE:
You do not need to power down the system to remove a power supply.
Steps
1. Rotate the power cable retention bail to the left. Remove the power cable from the power supply.
Figure 178. Removing the power cable
2. Push and hold the orange release tab to the left and grasp the power supply by its handle. Remove the power supply by
pulling it from the node.
Figure 179. Removing a power supply
Install a power supply
About this task
The power supplies in the NVMe expansion enclosure are installed upside down.
Steps
1. Align the power supply with the slot in the node. The power cable retention bail will be on the left.
148
NVMe expansion enclosure service procedures
Advertisement
Table of Contents
