Table of Contents
Advertisement
6. Position the new 2.5-inch storage drive on the storage drive bracket so that the four screws
2.5-inch storage drive align with the corresponding slots in the storage drive bracket. Slide the 2.5-inch
storage drive into position as shown.
Figure 56. Installing the 2.5-inch storage drive
7. Position the storage drive bracket on the system board so that the three slots on the storage drive
bracket align with the corresponding standoffs on the system board. Slide the storage drive bracket
as shown, until the screw hole in the storage drive bracket aligns with the corresponding mounting
stud on the system board, and the 2.5-inch storage drive is installed on the SATA 3.0 connector
on the system board.
Figure 57. Installing the storage drive bracket
124
ThinkCentre M600 Hardware Maintenance Manual
1
on the
Advertisement
Table of Contents
