Table of Contents
Advertisement
Figure 26
1. Cotter pin
2. Nut retainer
9.
Install the cotter pin and bend each legs around
the retainer
(Figure
10.
Install the dust cap onto the hub
11.
Repeat steps
1
through
at the other side of the machine.
Installing the Brakes and Wheels
1.
Clean the 2 flange-head bolts (3/8 x 3/4 inch) and
apply a coat of medium-strength thread-locking
compound to the threads of the bolts.
2.
Align the brake pads to either side of the rotor
(Figure
21) and the holes in the caliper bracket
with the holes in the brake mount of the spindle
frame
(Figure
25).
3.
Secure the caliper bracket to the spindle frame
(Figure
21) using the 2 flange-head bolts (3/8
x 3/4 inch).
Torque the 2 flange-head bolts to 47 to 54 N∙m
(35 to 40 ft-lb).
4.
Align the holes in the wheel to the studs of the
hub and assemble the wheel to the hub with the
valve stem outward
Note:
Ensure that the mounting surface of the
wheel is flush with the hub.
5.
Secure the wheel to the hub using the lug nuts
(Figure
20).
Torque the lug nuts to 108 to 122 N∙m (80 to 90
ft-lb).
6.
Repeat steps
1
through
wheel on the other side of the machine.
3. Dust cap
26).
(Figure
26).
10
for the hub and rotor
(Figure
20).
5
for the brake and
Engine Maintenance
Engine Safety
•
Shut off the engine, remove the key, and wait for
all moving parts to stop before checking the oil or
adding oil to the crankcase.
•
Keep your hands, feet, face, clothing, and other
body parts away from the muffler and other hot
surfaces.
g192345
Servicing the Air Cleaner
Servicing the Air-Cleaner Cover
Service Interval: Every 100 hours—Remove the
Every 100 hours—Clean out the debris in the
dust cap.
Check the air-cleaner body for damage which could
cause an air leak. Replace a damaged air-cleaner
body.
Clean the air-cleaner cover and remove the debris
from the dust cap
1. Dust cap
32
air-cleaner cover and clean out
the debris. Do not remove the
air-cleaner element.
(Figure
27).
Figure 27
g413899
Advertisement
Table of Contents
