Table of Contents
Advertisement
Maintaining the Machine under Special Operating
Conditions
Important:
If the machine is subjected to any of the conditions listed below, perform maintenance
twice as frequently:
•
Desert operation
•
Cold climate operation—below 10°C (50°F)
•
Frequent operation in dusty conditions
•
Construction work
•
After extended operation in mud, sand, water, or similar dirty conditions, do the following:
– Have your brakes inspected and cleaned as soon as possible. This prevents any abrasive material
from causing excessive wear.
– Wash the machine using water alone or with a mild detergent.
Important:
Do not use brackish or reclaimed water to clean the machine.
Pre-Maintenance
Procedures
Preparing the Machine for
Maintenance
1.
Park the machine on a level surface.
2.
Shift the transmission to the N
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
Removing the Seat
Assembly
Lift the seat assembly so that the tabs can slide out
of the frame brackets
position.
EUTRAL
26
(Figure
15).
Figure 15
g405486
Advertisement
Table of Contents
