Cutting Unit Maintenance; Separating The Cutting Unit From The Traction Unit - Toro 04022 Operator's Manual

Figure 43
1. Reel control cable
3. Tighten front cable jam nut.
4. Check control operation.

Cutting Unit Maintenance

Separating the Cutting Unit
from the Traction Unit
1. Place the mower on its drums on a level surface.
2. Lower kick stand. Insert a 1/4" dia. pin or equivalent
into frame hole above kick stand mounting bolt
(Figure 44).
1. 1/4" Pin
2. Handle
3. Remove grass basket.
4. Remove (2) bolts securing cutting unit pivot arms to
traction unit frame tube (Figure 45).
1. Cutting unit pivot arms
2. Traction unit frame tube
5. Rotate pivot arms forward (Figure 45) and rest
traction unit on restrained kickstand.
6. Pull cutting unit forward about 2 inch (51 mm)
and then to the right to disengage the transmission
coupling (Figure 46).
28
Figure 44
3. Kick stand
Figure 45
3. Bolts