Table of Contents
Advertisement
Figure 10
1. Left handle end
2. Locknut (M8–1.25)
3. Small spacer
4. Washer (M8)
6. Place a nut runner over the end of the spring pointing
towards the rear and move the end of the spring over
and under the kickstand spacer (Figure 11).
Figure 11
1. Spring
2. Spring end under the
frame
4
Adjusting the Handle
No Parts Required
Procedure
1. Remove hairpin cotters from ring pins on each side
of mower (Figure 12).
5. Large bolt (M8–1.25 x
100)
6. Spring
7. Large spacer
8. Ssmall bolt (M8–1.25 x
030)
3. Nut runner
4. Move the spring end under
the kickstand spacer.
1. Ring pins
2. While supporting handle, remove ring pins from
each side and raise or lower handle to desired
operating position (Figure 12).
3. Reinstall ring pins and hair pin cotters.
5
Installing the Transport
Wheels
Parts needed for this procedure:
Transport wheels (Optional Transport Wheel Kit,
2
Model 04123)
Procedure
1. Push kick stand down with foot and pull up on
handle support until kick stand has rotated forward,
over center (Figure 13).
12
Figure 12
Advertisement
Table of Contents
