Canon Inner Finisher-L1 Service Manual page 111

1. Adjust the center alignment by the following service mode.
• SORTER > ADJUST > CENT-ALG
Adjustment range: -10 to 10 (Unit: 0.1mm)
As the value is incremented by 1, the standard position for the center alignment moves by 0.1 mm.
+: Toward rear
-: Toward front
■ Right Angle Adjustment of Alignment Plate
<Use case>
• When remove or replace the alignment plate.
• When the paper alignment position is displaced.
<Procedure of adjustment>
CAUTION:
Perform the adjustment under either of the following states.
• The processing tray unit is stable with the bases such as paper stack.
• The processing tray is set in the inner finisher. However, remove the upper feed guide unit to access the screw for
adjustment.
Feed Direction
Feed Direction
104
Alignment Plate
+
-
+
-
Alignment Plate
Feed Direction
5. Adjustment