Canon Inner Finisher-L1 Service Manual page 110

1. Adjust return belt pressure by the following service mode.
• SORTER > ADJUST > RBLT-PRS
Adjustment range: -20 to 20 (Unit: 0.1 mm)
As the value is changed by 1, the height of the return belt changes by height of 0.1 mm.
+: Downward
-: Upward
■ Adjusting Center Alignment Standard Position
< Use case >
• When the standard position for the center alignment is misaligned.
• When misalignment occurs in front/rear direction.
< Procedure of adjustment >
CAUTION:
This adjustment influences alignment operation and staple position. Adjust the alignment width with
Alignment Position at Staple Mode" on page
Return belt
-
+
Feed Direction
101, "Adjusting the Alignment Position at Non-staple Mode" on page
103
Feed Direction
Feed Direction
5. Adjustment
− ＋
"Adjusting the
102.