Canon imagePASS-R1 Service Manual page 68

■ Install the system software through network connection
Using the Fiery Installer Builder you can install the system software stored on a network location. All the data on the HDD and
the configuration information will be lost, make sure to create a backup of the data or system configuration.
● To install the system software through the network connection
1. Remove all the USB devices that may be connected to the imagePASS.
2. If possible, print the Configuration pages (see
The Configuration pages contain a list of any installed options and a record of the customer's current Setup configuration.
3. Power on the Windows computer and do the following:
NOTE:
• Start the Fiery Installer Builder.
Double-click the Fiery Installer Builder icon on the desktop or you can also click Start > EFI > Fiery Installer Builder.
• Close all the software applications except the Fiery Installer Builder.
• Make sure that the Windows computer is configured to obtain its IP address automatically (DHCP).
• Remove any network cables between the Windows computer and the customer network.
• Disable all power-save and hibernation settings.
IMPORTANT:
It is important that you complete all of the tasks in the preceding list. If you do not complete these tasks, the installation
may fail.
4. At the Downloaded window of the Fiery Installer Builder, select imagePASS-R1 V1.0.
5. From the Preparation action list, select Perform Network installation.
"Printing the Configuration pages" on page
imagePASS-R1 V1.0
63
4. INSTALLING SYSTEM SOFTWARE
67).