How To Obtain The Fiery Password; Unlocking The Hdd - Canon imagePASS-R1 Service Manual

How to obtain the Fiery password

To log on to the imagePASS as an administrator or operator, you must obtain the Fiery password.
To obtain the Fiery password
1. Make sure that the imagePASS is connected to the printer.
2. Print the imagePASS Configuration page from the display panel on the imagePASS or the printer LCD panel.
Configuration pages" on page 67
3. On the imagePASS Configuration page, look for ID in the BIOS Setup section. The alphanumeric characters in the ID field is
the default password for the following:
• The administrator and operator password for the imagePASS.
4. After you log on to the imagePASS, change the Fiery password to prevent unauthorized usage.
NOTE:
Use Configure in WebTools or Fiery Setup Wizard to change the Fiery password.
Notes on the default password
• The Fiery documentation may mention "Fiery.1" as the default password. Do not use this password when you log on to the
imagePASS for the first time. Instead, use the password obtained in Step 3.
• If you reinstall the Fiery system software or restore factory default settings, the administrator password will be replaced by
"Fiery.1". Use "Fiery.1" to log on to the imagePASS and change the password.

Unlocking the HDD

HDD of imagePASS is Encryption.
If the motherboard has been replaced, Unlocking the HDD so that data in the HDD can be accessed.
Unlocking the HDD, go to WebTools and enter Fiery password.
1. Obtaining the Fiery Password
Default: Fiery Server Configuration > RIP > BIOS setup > ID (see Fiery password
page 9)
NOTE:
If the administrator has selected "Configure WebTools (by selecting Security > User Data Encryption)" and changed the Fiery
password, obtain the changed Fiery password.
2. HDD unlock method
1. Enter WebTools and enter Fiery password (see
(by selecting Security > User Data Encryption).
NOTE:
If the Fiery password is lost and you were not able to unlock the HDD, you still have five times to try the Fiery password. After all
the attempts fails, you will need to select to delete all data to restore to the factory default.
2. Follow the on-screen instructions to unlock the HDD. After unlocking the HDD, restart the imagePASS.
"How to obtain the Fiery password" on page
9
1. Introduction
"To print the
"How to obtain the Fiery password" on
9) in the Configure WebTools