Canon imagePASS-R1 Service Manual page 35

4. Install the security chip in socket J23 on the new motherboard.
NOTE:
Be sure to align the small notch in the security chip with the notch in the outline that appears inside socket J23.
If you install the security chip incorrectly, you may corrupt the security chip and/or the motherboard.
No.
1 J23
2 Security chip
3 Align notches
■ Replacing the motherboard
Use the following procedure to install the motherboard in the imagePASS chassis.
● To replace the motherboard
1. If you are installing a new motherboard, do the following:
• Remove the security chip from the old motherboard and install it onto the new motherboard (see
security chip" on page
• Install the DIMM(s) from the old motherboard onto the new motherboard (see
• Install the CPU from the old motherboard onto the new motherboard (see
32).
When installing these components, make sure that the motherboard is placed on an antistatic surface with some padding.
Do not transfer the BIOS chip from the old motherboard onto the new motherboard. Doing so can cause the system to shut
down due to incompatibility issues.
1
2
Figure 16: Aligning the security chip
28).
3
Name
"DIMM" on page
"CPU and CPU cooling assembly" on page
30
3. REPLACING PARTS
"Transferring the
22).