NorthStar 6000i Quickstart Manual And Reference Manual page 145

ALARM ALARM MESSAGE
ICON
GPS
COMMUNICATION
FAILURE
NO LORAN
POSITION FIX
LORAN
COMMUNICATION
FAILURE
YOU'VE PASSED
WAYPT: 'NAME'
POOR LORAN
SIGNALS
NO NETWORK
Reference Manual Revision D
Table 4: 6000i alarms (continued)
ACTIVATED WHEN . . .
The GPS receiver may have failed.
Position fix from an external loran receiver is
unavailable and external loran is the chosen
position source. This alarm is delayed for three
minutes at power-up.
The 6000i hasn't received any messages from
the external loran receiver for over 30 seconds.
Vessel has passed abeam of the active way-
point — without entering the arrive radius. This
alarm only appears if there are NO future way-
points, or if waypoint switching is manual.
BLINK, CYCLE or LOW SNR detected by the
external loran used as the position source.
A 6000i designated as a slave and requiring a
master to be present on the network is not
receiving networking signals.
Sounder alarms (shown only if the sounder is enabled)
CONTROLLED CLEARS
ON ALARM AFTER
SCREEN? TIME–OUT?
No No
No No
No No
No YES,
10 seconds
No No
No No
Reference section 8 — Alarms and TideTrack
CLEARS
WHEN
OK?
No
YES
No
YES
YES
YES
141
Alarms