Replacing The Static Strap; Servicing The Batteries; Maintaining The Lithium-Ion Batteries - Toro e-Dingo 500 Operator's Manual

Compact tool carrier
Hide thumbs Also See for e-Dingo 500:
Table of Contents

Advertisement

Figure 31
1. Battery-disconnect
switch—O
position
FF
5.
Close the cover and push the latch down.

Replacing the Static Strap

Service Interval: Before each use or daily—Check
the static strap; replace it if worn or
missing.
1.
Park the machine on a level surface and lower
the loader arms.
2.
Shut off the machine and remove the key.
3.
Under the platform, replace the static strap as
shown.
Figure 32
1. Nut
2. Bolt
g387539
2. Battery-disconnect
switch—O
position
N
g387663
3. Static strap

Servicing the Batteries

Note:
The machine is equipped with 6 lithium-ion
batteries.
A lithium-ion battery must be disposed of or recycled
in accordance with local and federal regulations. If
a battery requires service, contact your Authorized
Service Dealer for assistance.
Do not open the battery. If you are having problems
with a battery, contact your Authorized Service Dealer
for assistance.
Maintaining the Lithium-Ion
Batteries
WARNING
The batteries contain high voltage, which
could burn or shock you.
• Do not attempt to open the batteries.
• Use extreme care when handling a battery
with a cracked case.
• Use only the charger designed for the
batteries.
The lithium-ion batteries hold a sufficient charge to
perform intended work during its life span.
To achieve maximum life and use from your batteries,
follow these guidelines:
Do not open the battery.
Store/park the machine in a clean, dry garage or
storage area, away from direct sunlight, heat
sources, rain, and wet conditions. Do not store
it in a location where the temperature exceeds the
range specified in
(page
38).
Important:
Temperatures outside of this range
will damage your batteries. High temperatures
during storage, especially at a high state of
charge, reduces the life of the batteries.
When storing the machine for more than 10 days,
ensure that the machine is in a cool and dry
location, out of sunlight, rain, and wet conditions.
If you are using the machine hot conditions or in
strong, direct sunlight, the battery may overheat.
If this happens, a high-temperature alert appears
on the InfoCenter and machine functionality may
be reduced.
30
Battery Storage Requirements

Advertisement

Table of Contents
loading

This manual is also suitable for:

2221922219g

Table of Contents