Toro e-Dingo 500 Operator's Manual page 23

Compact tool carrier
Hide thumbs Also See for e-Dingo 500:
Table of Contents

Advertisement

Loading the Machine
WARNING
Loading or unloading a machine onto a trailer
or truck increases the possibility of tip-over
and could cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Load and unload the machine with the
heavy end up the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
1.
If using a trailer, connect it to the towing vehicle
and connect the safety chains.
2.
If applicable, connect the trailer brakes.
3.
Lower the ramp(s).
4.
Lower the loader arms.
5.
Load the machine onto the trailer with the heavy
end up the ramp, carrying loads low, as shown.
If the machine has a full load-bearing
attachment (e.g., bucket) or a
non-load-bearing attachment (e.g.,
trencher), drive the machine forward up the
ramp.
If the machine has an empty load-bearing
attachment or no attachment, back the
machine up the ramp.
Figure 21
1. Machine with full
attachment or
non-load-bearing
attachment—drive the
machine forward up the
ramp(s).
6.
Lower the loader arms all the way down.
7.
Engage the parking brake (if equipped), shut off
the machine, and remove the key.
8.
Use the metal tie-down loops on the machine
to securely fasten the machine to the trailer or
truck with straps, chains, cable, or ropes. Refer
to local regulations for tie-down requirements.
g237904
2. Machine with empty or
no attachment—back the
machine up the ramp(s).
1. Tie-down loops
Unloading the Machine
1.
Lower the ramp(s).
2.
Unload the machine from the trailer with the
heavy end up the ramp, carrying loads low.
If the machine has a full load-bearing
attachment (e.g., bucket) or a
non-load-bearing attachment (e.g.,
trencher), back it down the ramp.
If the machine has an empty load-bearing
attachment or no attachment, drive it forward
down the ramp.
1. Machine with full
attachment or
non-load-bearing
attachment—back the
machine down the
ramp(s).
23
Figure 22
Figure 23
2. Machine with empty or
no attachment—drive the
machine forward down the
ramp(s).
g387052
g237905

Advertisement

Table of Contents
loading

This manual is also suitable for:

2221922219g

Table of Contents