Mounting The Tooth Rake To The Traction; Unit; Adjusting The Link Assembly - Toro Sand Pro 3040 Operator's Manual

2
Mounting the Tooth Rake to
the Traction Unit
Parts needed for this procedure:
2 Bolt (3/8 x 2-1/2 inches)
4 Washer (3/8 x 7/8 inch)
2 Spacer
2 Locknut (3/8 inch)
Procedure
1. Remove any attachment from the rear of the
machine.
2. Lower the traction unit adapter and back
the traction unit into position in front of the
attachment adapter.
Note:
Make sure the locking lever is pivoted to
the left (unlocked position) as viewed from the
rear of the machine.
3. Slide the attachment adapter onto the traction
adapter.
Important:
The long arm of the lift arm
assembly must be under the traction unit
rear frame assembly
CAUTION
You could pinch your fingers between the
attachment and traction unit adapters.
Always lift and move the attachment
using the handle on the back of the
attachment adapter
4. Pivot the locking lever to the right to lock the
adapters together.
5. Secure the top link of each chain to the outside
of the lift arm (Figure
inches), 2 washers (3/8 x 7/8 inch), a spacer,
and a locknut (3/8 inch).
(Figure 6).
(Figure 6).
6) using a bolt (3/8 x 2-1/2
1. Tube frame of the traction

unit

2. Long arm of the lift arm
assembly
3. Bolt (3/8 x 2-1/2 inches)
4. Washer (3/8 x 7/8 inch)
Note:
For proper operation of the rake, the
chains must be slack when the rake is in the
lowered (operating) position.
Note:
Make sure that all the finishing rakes
overlap properly, laying flat with none of the
chains tangled or twisted.
3
Adjusting the Link
Assembly
No Parts Required
Procedure
1. With the rake mounted and secured on the
traction unit, raise the attachment.
2. Measure the gap between the heavy washer and
the shoulder of the lift yoke on the attachment
adapter as shown in
Note:
The link is adjusted correctly if you
measure a gap—1.5 to 2 mm (0.060 to 0.080
inch) between the heavy washer and the lift-yoke
shoulder (Figure
6
Figure 6
5. Spacer
6. Chain
7. Locknut (3/8 inch)
Figure 7.
7).
g220791