Operation Using The Operation Panel (Pu Operation) - Mitsubishi Electric FATEC FR-A800 Manual

2
UNDERSTANDING INVERTER SYSTEM
2.5.7

Operation using the operation panel (PU operation)

Use the operation panel (FR-DU08) to give a start command and a frequency command. (PU
operation)
Operation example
Turning ON the power of the inverter
1.
The operation panel is in the monitor mode.
Changing the operation mode
2.
Press
Setting the frequency
Turn
seconds.
While the indication is blinking, press
3.
displayed alternately. The value blinks for approximately three seconds and the indication goes back to "
(monitor display).
(If
that case, turn
Start → acceleration → constant speed
Press
4.
F010 (Pr.7) Acceleration time, and "
(To change the set frequency, perform the operation in above step 3. The previously set frequency appears.)
Deceleration → stop
Press
5.
(Pr.8) Deceleration time, and "
2.5 How to use the operation panel FR-DU08
18
Operation panel (FR-DU08)
Operate at 30 Hz.
to choose the PU operation mode. The [PU] indicator turns ON.
until the target frequency "
is not pressed, the indication of the value goes back to "
again and set the frequency.)
or to start running. The frequency value on the monitor increases according to the setting of
to stop the motor. The frequency value on the monitor decreases according to the setting of F011
" (0.00 Hz) appears. Then, the motor stops rotating.
Operation
" (30.00 Hz) appears. The indication blinks for approximately five
to confirm the selection for the frequency. "
" (0.00 Hz) after about 5 s of blinking. In
" (30.00 Hz) appears on the monitor.
" and " " are
"